Check the following points

• Do the documents meet the paper requirements?

• Is there any foreign matter in the ADF?

• Are the pick rollers, separator roller and brake roller installed correctly?

• Are the pick rollers, separator roller and brake roller clean?

• Are the pick rollers, separator roller and brake roller worn out?

• Did you adjust the paper separation force on the operator panel?

If the problem persists, check the items in Before You Contact the Scanner Service Provider first, then contact the distributor/dealer where you purchased this product. Refer to the contact information in the Contact List or the Contact for Inquiries section in Safety Precautions bundled with this product and make an inquiry.

Do the documents meet the paper requirements?

Solution

Use documents that meet the requirements.

For details, refer to Documents for Scanning.

Is there any foreign matter in the ADF?

Solution

Clean the ADF.

Remove any foreign matter from the ADF.

For details, refer to Daily Care.

Are the pick rollers, separator roller and brake roller installed correctly?

Solution

Install the pick rollers, separator roller and brake roller correctly.

For details, refer to Replacing the Pick Roller, Replacing the Separator Roller, and Replacing the Brake Roller.

Are the pick rollers, separator roller and brake roller clean?

Solution

Clean the pick rollers, separator roller and brake roller.

For details, refer to Daily Care.

Are the pick rollers, separator roller and brake roller worn out?

Solution

Use one of the following methods to check the pick roller, separator roller, and brake roller counters, and replace the pick rollers, separator roller, and brake roller if necessary.

• You can select [23: Show/Clear Counters] from [Main Menu] on the operator panel to check the number of sheets that have been scanned.

  For details, refer to Checking and Resetting the Counters.

• You can start up the Software Operation Panel to check the number of sheets that have been scanned.

  For details, refer to Checking the Sheet Counters.

For details about replacing the pick rollers, separator roller, and brake roller, refer to Replacing the Pick Roller, Replacing the Separator Roller, and Replacing the Brake Roller.

Did you adjust the paper separation force on the operator panel?

Solution

Lower the paper separation force if it is set high.

For details, refer to Adjusting the Paper Separation Force.