Checking the Information

Checking the Information
  1. Press the power button on the front of the scanner.

    [Ready] is displayed on the LCD.

  2. Press the [Menu] button.

    [Main Menu] is displayed on the LCD.

  3. Press the [White triangle pointing up] or [White triangle pointing down] button and select [Information], then press the [Function/Enter] button to confirm.

    [Information] is displayed on the LCD.

    ATTENTION

    [Information] can be selected only when there is a message for replacing consumables/cleaning/replacing maintenance parts/regular maintenance.

  4. Press the [White triangle pointing up] or [White triangle pointing down] button to check the contents of the information.

    You can check the messages for replacing consumables/cleaning/replacing maintenance parts/regular maintenance.

    When the message prompts replacing consumables/maintenance parts or cleaning, the corresponding counter that requires consumable replacement/maintenance part replacement/cleaning is highlighted.

    Counters will appear highlighted when:

    • The page count after replacing the consumable reaches 95% of the value configured in Specifying the Cycle to Replace Consumables [Life Counter Alarm Setting] in the Software Operation Panel. (For brake roller/pick roller/separator roller counters)

    • The scanner determines that the condition of the roller has exceeded the threshold that can be corrected, by monitoring the wear on the roller. (For assist roller counter)

    • The page count after cleaning reaches 100% of the value configured in Scanner Cleaning Cycle [Cleaning Cycle] in the Software Operation Panel. (Cleaning counter)

    • The amount of remaining ink reaches below 33%. This is only displayed when the imprinter is installed. (For [Ink Level:Front] / [Ink Level:Back])

  5. Take measures according to the contents of [Information].

    Follow the instructions in the message if it prompts consumable replacement/cleaning/maintenance part replacement.

    For information on how to replace consumables, refer to the following:

    For details about cleaning, refer to Daily Care.

    Maintenance parts (assist roller) require a service engineer to perform replacement.

    For details, contact a service engineer. Refer to the contact information in the Contact List or the Contact for Inquiries section in Safety Precautions bundled with this product and make an inquiry.

    If the message prompts regular maintenance, please have the scanner checked by a service engineer for regular maintenance/inspection.

    For details, contact a service engineer. Refer to the contact information in the Contact List or the Contact for Inquiries section in Safety Precautions bundled with this product and make an inquiry.