Displayed when the scanner is turned on.

Indicates that the initialization is in process after the scanner is turned on.

Indicates that the initialization is in process and is near the end of process after the scanner is turned on.

Ready to start scanning.

Indicates that the initialization is successfully complete.

This is referred to as "ready" status.

After overlapped documents are detected, the function number flashes.

This indicates that you can determine whether or not to memorize the overlap pattern.

For details, refer to Configuring Not to Detect Certain Overlap Patterns.

Indicates that the scanner is in a ready status and the ADF is open.

In this case, the LED indicator also flashes.

When the ADF is closed, the display returns to the ready status ("1").

For information on how to close the ADF, refer to How to Close the ADF.

If the display does not return to the ready status ("1") even after the ADF is closed, turn the power off then back on.

If the indication continues to appear after turning the power back on, contact the distributor/dealer where you purchased this product. Refer to the contact information in the Contact List if supplied with this product, or refer to the contact information in the Contact for Inquiries section if provided in Safety Precautions supplied with this product, and then make an inquiry.

Indicates that the [Send to] button was pressed to pause the scan.

Press the [Scan/Stop] button to resume the paused scan.

Displayed when the [Send to] button is pressed while the scanner is in a ready status.

Displayed when the [Scan/Stop] button is pressed while the scanner is in a ready status.

Indicates that an error occurred during scanning.

The letter "J", "n", or "U" and an number appear alternately. A letter combined with a number is an "error code".

For details about errors, refer to Errors.

Press the [Scan/Stop] button/[Send to] button in this status to return to the ready status ("1").

Indicates that an error occurred on the scanner itself.

The letter "A", "C", "E", "F", "H", "L", or "n" and a number appear alternately. A letter combined with a number is an "error code".

For details about errors, refer to Errors.

Press the [Scan/Stop] button/[Send to] button in this status to return to the ready status ("1").

When this error appears, turn the power off then back on.

If the problem still persists, write down the error code, check each item in Before You Contact the Scanner Service Provider and then contact the distributor/dealer where you purchased this product. Refer to the contact information in the Contact List if supplied with this product, or refer to the contact information in the Contact for Inquiries section if provided in Safety Precautions supplied with this product, and then make an inquiry.