Setting the Waiting Time to Enter Power Saving Mode [Power saving]

When the scanner is not being used for a certain period of time, it enters power saving mode to save the power consumption.

  1. Start up the Software Operation Panel.

    Refer to Starting Up the Software Operation Panel.

  2. From the list on the left, select [Device Setting].
    The Waiting Time to Enter Power Saving Mode
  3. Use the slide bar to specify the waiting time to enter power saving mode.

    The value can range from 5 to 115 minutes (in increments of 5).

    HINT

    When you select the [Power off after a certain period of time] check box, the scanner will turn itself off automatically if it is turned on and left unused for the set time.

    The time until power-off can be selected from 1/2/4/8 hours.