Specifying the Sensitivity Level and Detection Range for Paper Protection [Paper Protection Sensitivity]

You can specify the sensitivity and the detection range to detect documents that are fed abnormally when Paper Protection is enabled.

Documents are deformed (e.g. warped, bent, creased) when they are not being fed by the rollers properly. To detect such a symptom and stop the scan, select [Low] to only detect documents that are highly deformed, and [High] to also detect documents that are slightly deformed.

Select [Large] when you want to widen the detection range.

  1. Start up the Software Operation Panel.

    Refer to Starting Up the Software Operation Panel.

  2. From the list on the left, select [Device Setting 2] → [Paper Protection Sensitivity].
    Paper Protection Sensitivity
  3. Specify the sensitivity for Paper Protection.
    Low

    Decreases the sensitivity level to detect warped documents.

    Normal

    Monitors the documents in normal sensitivity.

    Keep this setting for normal use.

    High

    Increases the sensitivity level to detect warped documents.

    HINT

    • If paper jams occur frequently at the feeding position, select [Low].

    • This setting can also be configured from the operator panel. Note that you can prioritize the operator panel setting.

  4. Specify the detection range for Paper Protection.
    Normal

    The detection range is normal.

    Large

    Widens the detection range.