Shortening the Scanning Intervals [Pre-Pick]

"Pre-Pick" refers to feeding the document to the starting position for scanning before the next scan.

Enabling [Pre-Pick] shortens the interval between scanning each document.

  1. Start up the Software Operation Panel.

    Refer to Starting Up the Software Operation Panel.

  2. From the listing on the left, select [Device Setting 2] → [Pre-Pick].
    Pre-Pick
  3. Specify whether or not to enable pre-pick.

    Select [Yes] to enable and [No] to disable Pre-pick.

    HINT

    • If you cancel in the middle of scanning while Pre-Pick is enabled, you will have to remove the pre-picked document, then load the document again.

    • This setting can also be configured in the scanner driver's setup dialog box. Note that priority is given to the scanner driver setting.