Setting the Maintenance/Inspection Cycles for the Scanner [Maintenance and Inspection Cycle]

You can specify the cycle of regular maintenance/inspection by a service engineer.

A message for regular maintenance appears when the time specified here elapses after the last time regular maintenance/inspection was performed. Messages for regular maintenance can be checked in [Information] of the operator panel.

  1. Start up the Software Operation Panel.

    Refer to Starting Up the Software Operation Panel.

  2. From the list on the left, select [Device Setting 2] → [Maintenance and Inspection Cycle].
    Setting the Maintenance/Inspection Cycles for the Scanner
  3. Select whether to enable or disable [Maintenance and Inspection Cycle].

    When you enable this setting, select a cycle for maintenance/inspection by a service engineer.