Device Setting

  1. Start up the Software Operation Panel.

    Refer to Starting Up the Software Operation Panel.

  2. From the list on the left, select [Device Setting].
    Device Setting

    Items that can be configured in the above dialog box are as follows:

    Item

    Description

    Setting/Value

    Factory Default

    Count

    Check the replacement cycle of the consumables and the total page count of the maintenance parts.

    Also use it to reset the counter when you have replaced the consumables or performed cleaning.

    Total Page Count(ADF) / After cleaning / Brake Roller / Pick Roller / Separator Roller / Assist Roller

    0

    Ink Level:Front / Ink Level:Back

    (when the imprinter option is installed)

    Only displayed when imprinter is installed

    Power saving

    Specify the waiting time before entering power saving mode.

    Range: 5 min. to 115 min. (in increments of 5 min.)

    15 min.

    Power off after a certain period of time: Select to have the scanner turn off automatically when it is turned on and left unused for a certain period of time.

    Also, specify the time until power-off.

    [Power off after a certain period of time] check box

    Selected

    1 Hour/2 Hours/4 Hours/8 Hours

    (when the [Power off after a certain period of time] check box is selected)

    4 Hours

    Offset Setting

    Adjust the position to start scanning for the specified scanning side(s).

    Unit:

    ADF (Front) / ADF (Back)

    Main/Sub: -2 to 3 mm (in increments of 0.5 mm)

    Main/Sub: 0 mm

    Vertical magnification Adjustment

    Adjust the magnification level in the feeding direction for the specified scanning method.

    Unit: ADF

    Range: -3.1 to 3.1% (in increments of 0.1%)

    0%