Waiting Time for the Scanner to Enter Power Saving Mode [Power saving]

Specify the waiting time before the scanner enters power saving mode.

  1. Start up the Software Operation Panel.

    For details, refer to Starting Up the Software Operation Panel.

  2. From the list on the left, select [Device Setting].
    Power saving
  3. Specify the waiting time for the scanner to enter power saving mode.
    Power saving

    Use the slider to specify the waiting time before entering power saving mode in the range from 5 to 115 minutes (in increments of 5).

    The factory default setting is "10" minutes.

    Power off after a certain period of time checkbox

    Select this when you turn off the scanner automatically.

    When this is selected, the scanner is turned off automatically if it is left on without being used for a certain period of time.

    The check box is selected for the factory default setting.

    You can select the timeout period for the scanner to be automatically turned off by [1 Hour]/[2 Hours]/[4 Hours]/[8 Hours].

    The factory default setting is "4 Hours".