Settings for Saving the Power Consumption of the Scanner [ECO Mode]

Specify this to save the power consumption of the scanner by slowing down the scanning speed.

  1. Start up the Software Operation Panel.

    For details, refer to Starting Up the Software Operation Panel.

  2. From the list, select [Device Setting 2] → [ECO Mode].
  3. Select [Enable] to save the power consumption of the scanner.

    The factory default setting is [Disable].

    ATTENTION

    When scanning long page documents while [ECO Mode] is enabled, the scanner may fail to completely scan documents up to the maximum length due to the resolution settings in the scanner driver.

    For details about supported document lengths, refer to Did you scan long page documents while [Low-speed Feed Mode], [ECO Mode] or with [Manual Single Mode using Straight Scan] is enabled?.

    TIP

    This setting can also be configured in the operator panel.