The procedures to switch between document feeding methods are as follows.

• Switching to U-turn Scan

  U-turn Scan enables you to scan documents in the following ways:

  • Documents can be scanned continuously.

  • By using Manual Continuous Mode, multiple documents can be loaded manually and scanned in succession.

  • By using Manual Single Mode, documents folded in half, envelopes, and multi-layered transfer paper with a thickness of 0.50 mm or less can be manually scanned one at a time.

  When documents loaded on the hopper are scanned, the scanned documents are ejected onto the stacker.

• Switching to Straight Scan

  Straight Scan enables you to scan documents in the following ways:

  • Documents can be scanned continuously.

  • By using Manual Continuous Mode, multiple documents can be loaded manually and scanned in succession.

  • By using Manual Single Mode, envelopes or booklets with a thickness of 1.25 mm or less (thick envelopes or thin booklets) can be manually scanned one at a time.

  Straight Scan enables you to scan thicker documents than with Manual Continuous Mode or Manual Single Mode with U-turn Scan, however the scanning speed is reduced.

  When a document on the hopper is scanned, the scanned document is ejected from the back of the scanner.

• Switching to Manual Continuous Mode

  Manual Continuous Mode enables you to manually load more than one document and scan them in succession.

• Switching to Manual Single Mode

  When using U-turn Scan, Manual Single Mode enables you to manually scan documents folded in half, envelopes, or multi-layered transfer paper with a thickness of 0.50 mm or less one at a time.

  When using Straight Scan, Manual Single Mode enables you to manually scan envelopes or booklets with a thickness of 1.25 mm or less (thick envelopes or thin booklets) one at a time.