Situation in Which the Document Is not Fed into the ADF Occurs Frequently
- Check the following points
-
If the problem still persists, check each item in Before You Contact the Scanner Service Provider first, then contact the distributor/dealer where you purchased this product. Refer to the contact information in the Contact List if supplied with this product, or refer to the contact information in the Contact for Inquiries section if provided in Safety Precautions supplied with this product, and then make an inquiry.
Do the documents meet the paper requirements?
- Solution
Use documents that meet the requirements.
For details, refer to Documents for Scanning.
Did you fan the documents before loading them?
- Solution
Fan the documents.
For details, refer to Preparing Documents to Load Them in the ADF Paper Chute (Feeder).
Are the brake roller and pick roller installed correctly?
- Solution
Install the brake roller and pick roller correctly.
For details, refer to Replacing the Brake Roller and Replacing the Pick Roller.
Are the brake roller and pick roller clean?
- Solution
Clean the brake roller and pick roller.
For details, refer to Daily Care.
Are the brake roller and pick roller worn out?
- Solution
-
Check the counters for the brake roller and pick roller.
For fi-8190/fi-8290/fi-8170/fi-8270
Check the counters for the brake roller and pick roller with one of the following methods.
Check the counters for the brake roller and pick roller in [5:Consumable counters] on the [Settings Menu] screen of the operator panel.
For details, refer to How to Use Settings Menu.
Check the counters for the brake roller and pick roller in the Software Operation Panel.
For details, refer to Checking the Sheet Counters.
For fi-8150/fi-8250/fi-8150U/fi-8250U
Check the counters for the brake roller and pick roller in the Software Operation Panel.
For details, refer to Checking the Sheet Counters.
If necessary, replace the brake roller and pick roller.
For details, refer to Replacing the Brake Roller and Replacing the Pick Roller.