Waiting Time in Manual Feeding [Manual Feeding]

Configure the settings when manually loading and scanning one sheet at a time.

When you scan by manually loading one sheet at a time, you can specify the waiting time (interval) for loading the next document in the ADF paper chute (feeder). This enables continuous scanning as long as you load a document within the specified time.

If the specified time is exceeded, the scan is finished automatically.

  1. Start up the Software Operation Panel.

    For details, refer to Starting Up the Software Operation Panel.

  2. From the list on the left, select [Device Setting 2] → [Manual Feeding].
  3. Set [Timeout Time].

    For [Timeout Time], specify the time period until which the scanner confirms that no documents are loaded in the ADF paper chute (feeder) (the interval between the last scan and the detection of whether the next document is loaded or not).

    The factory default setting is "10 seconds".

    • When scanning more than one document in succession manually

      1. Select [Enable] for [Continuous Feed Mode] to switch the feed mode to Manual Continuous Mode.

      2. Select the time for [Timeout Time].

    • When scanning a document folded in half, an envelope, a multi-layered transfer paper, or a booklet such as a passport manually and one at a time

      1. Press the [Manual Feed] button to switch the feed mode to Manual Feed Mode.

      2. Select the time for [Timeout Time].

    HINT

    • You can select whether to scan documents in succession in Manual Feed Mode for [Manual Feed Mode].

      When [Do not continue] is selected, Manual Feed Mode is cleared after scanning is complete.

      When [Continue] is selected, documents are scanned in succession in Manual Feed Mode until the [Manual Feed] button is pressed.

      The factory default setting is [Do not continue].

    • In Manual Continuous Mode or Manual Feed Mode, the scanner will wait for documents to be loaded in the ADF paper chute (feeder) until the timeout time elapses after scanning is started or a document is ejected.

      Scanning will stop if no document is loaded within the timeout time.

      To immediately stop scanning, press the following button depending on the scanner.

      • For fi-8190/fi-8290/fi-8170/fi-8270

        [Stop/Clear] button

      • For fi-8150/fi-8250/fi-8150U/fi-8250U

        [Send to] button

    • The setting for switching the feed mode to Manual Feed Mode can also be configured in the scanner driver.

      For details, refer to the help for the scanner driver.

    • For fi-8190/fi-8290/fi-8170/fi-8270, this setting can also be configured in the operator panel.