Scanning Slowly at Low Resolution [Low-speed Feed Mode]

Specify this to slow down the scanning speed in order to protect the documents.

When performing a scan at a low resolution (lower than 400 dpi), the scan is performed at a slow speed regardless of the resolution that is set. This setting is effective for scanning long page documents.

  1. Start up the Software Operation Panel.

    Refer to Starting Up the Software Operation Panel.

  2. From the list on the left, select [Device Setting 2] → [Low-speed Feed Mode].
  3. Select [Enable] if you perform a slow scanning speed in order to protect the documents.

    The factory default setting is [Disable].

    HINT

    For fi-8190/fi-8290/fi-8170/fi-8270, this setting can also be configured in the operator panel.