Conditions for Mixed Batch Scanning
The following conditions apply when a mixed batch of documents with different paper weights/friction coefficients/sizes is scanned.
Make sure to test a few sheets first to check if the mixed batch of documents can be fed.
For details about scanning, refer to Scanning Documents with Different Widths.
- Paper Direction
Align the direction of the paper fiber with the feed direction.
- Paper Weight (Thickness)
When scanning documents with different paper weight in the same batch, keep the paper weight within the following range:
27 to 413 g/m2 (7.2 to 110 lb)
- Friction Coefficient
It is recommended that the same paper brand from the same manufacturer is used for documents.
When different paper manufacturers/brands are mixed in documents to be scanned, it affects the feeding performance as the difference in friction coefficient increases.
The following friction coefficients are recommended:
0.35 to 0.60 (reference value for paper friction coefficient)
- Document Position
Load all documents covering the width of the pick roller (approx. 39 mm/1.54 in. wide).
For a guideline for mixed batch scanning, refer to Combinations of Standard Paper Sizes in a Mixed Batch in Paper Size.
HINTWhen the smallest document covers the width of the pick roller even when it is loaded towards one side as shown in the image below, load documents aligned on one side. So that it prevents documents from skewing when being fed.
- Paper Size
When a mixed batch with different sizes is scanned, not feeding the documents straight may cause troubles such as paper jams or part of the image to appear missing.
It is recommended that you check the scanned images if the documents were fed skewed.
ATTENTIONWhen a mixed batch with different sizes is scanned, documents are more likely to skew because the side guides do not fit every sheet properly.
Do not specify the detection method by document length when scanning a mixed batch of documents with different lengths and detecting overlapped documents.
- Combinations of Standard Paper Sizes in a Mixed Batch
Refer to the table below for a guideline of the range available for mixed batch scanning.
LTR: Letter size
A3-CS: Carrier Sheet
*1: The following figure shows how to set the widest and the narrowest documents of the batch between the side guides.
ATTENTIONB8 (portrait) and A8 (portrait) documents cannot be mixed with other sizes in the same batch.
- Documents That Cannot Be Scanned in a Mixed Batch
The following types of documents cannot be mixed in the same batch:
Carbonless paper
Bond paper
Perforated documents
Thermal paper
Carbon-backed paper
OHP film
Tracing paper