Though you attempted to scan a whole document batch in Document Count Check mode with the document count pre-configured in Doc Counting mode, less document sheets were scanned.

If there are some sheets to scan, load them on the hopper and click the [Retry] button to continue the scan.

If there is no sheet to scan, click the [Cancel] button, then check if the number of scanned sheets is less than the settings configured, and check if there are any sheets not scanned correctly.

To resume the scan, select either of the following ways:

• To continue the scan in Document Count Check mode without resetting the counted value

  Load additional documents on the hopper, and then start scanning.

• To reset the counted value, and continue the scan in Document Count Check mode under the same document count configurations

  Press the [Counter Reset] button on the scanner's operator panel, and then start scanning.

• To clear the Document Count Check mode, and continue the scan

  Press the [Stop] button on the scanner's operator panel, and then start scanning.