Though you had scanned a whole document batch in Document Count Check mode with the document count pre-configured in Doc Counting mode, some more document sheets remain on the hopper.

Click the [OK] button to end the scan, and make sure that no extra documents are included in the batch.

To resume the scan, select either of the following ways:

• To reset the counted value, and continue the scan in Document Count Check mode under the same document count configurations

  Press the [Counter Reset] button on the scanner's operator panel, and then start scanning.

• To clear the Document Count Check mode, and continue the scan

  Perform one of the following.

  • Press the [Stop] button on the scanner's operator panel, and then start scanning.

  • Start scanning directly.