Basic Specification
Item |
Specification |
|
|---|---|---|
Scanner type |
ADF (Automatic Document Feeder) Manual feeding (Single/Continuous) is available with the ADF. |
|
Image sensor |
Color CCD × 2 (front, back) |
|
Light source |
White LED × 2 (front, back) |
|
Scanning area (width × length) |
Minimum size |
50.8 × 54 mm/2 × 2.1 in. 54 × 50.8 mm/2.1 × 2 in. |
Maximum size |
A4 (portrait) (210 × 297 mm/8.3 × 11.7 in.) (*1) Legal (portrait) (8.5 × 14 in.) (*1) |
|
Paper weight (thickness) |
27 to 413 g/m2 (7.2 to 110 lb) For A8 size or smaller, 128 to 209 g/m2(34 to 56 lb) 1.4 mm or less for plastic cards (*2) |
|
Scanning speed (A4, Portrait, 300 dpi) (*3) |
For USB connection |
Simplex: 60 ppm, Duplex: 120 ipm |
For wired LAN connection |
Simplex: 60 ppm, Duplex: 120 ipm |
|
For Wi-Fi connection |
Simplex: 60 ppm, Duplex: 120 ipm |
|
Loading capacity (*4) |
80 sheets Paper weight: 80 g/m2 (20 lb) Total thickness: 8 mm (0.3 in.) or less |
|
Optical resolution |
600 dpi |
|
Output resolution |
Binary (black & white) |
50 to 600 dpi (configurable in 1 dpi increments) 1,200 dpi (created by scanner driver) |
Grayscale |
||
Color |
||
Multi-valued level |
Color: 24-bit Grayscale: 8-bit Binary (black & white): 1-bit |
|
Interface |
USB |
USB 3.1 Gen 1/USB 3.0/USB 2.0/USB 1.1 (*5) Type B |
Wired LAN |
IEEE802.3 Ethernet 10BASE-T/100BASE-TX/1000BASE-T RJ-45 |
|
Wi-Fi |
For details, refer to Specifications of Wi-Fi. |
|
Network protocol (wired LAN, Wi-Fi) |
IPv4 (*6), TCP, UDP, ICMP, DHCP, DNS HTTP/HTTPS |
|
Touch screen |
4.3-inch TFT color touch screen Pressure-sensitive |
|
Contactless Smart Card Reader |
Communication mode
|
|
| *1: | Long page scanning supports documents with a length up to 5,588 mm (220 in.) when the resolution is set to 200 dpi or lower. |
||||||||
| *2: | Up to three plastic cards can be loaded in the ADF paper chute (feeder). |
||||||||
| *3: | Note that this is the hardware limitation, and the software's processing time such as data transfer time is added to the actual time of scanning. The system environment used for measuring scan speed is as follows:
|
||||||||
| *4: | The capacity varies depending on the paper weight. For details, refer to Documents for Scanning. |
||||||||
| *5: | Use the USB cable that is supplied. When connecting the USB cable to a USB hub, make sure you connect it to a USB hub that is connected to the USB port of a computer. Connection with USB 3.1 Gen 1/USB 3.0/USB 2.0 requires the USB port and the hub to support USB 3.1 Gen 1/USB 3.0/USB 2.0. Also note that the scanning speed slows down when USB 1.1 is used. |
||||||||
| *6: | IPv6 is not supported. |
Specifications of Wi-Fi
Item |
Specification |
|---|---|
Observed standards |
IEEE802.11a IEEE802.11b IEEE802.11g IEEE802.11n IEEE802.11ac |
Communication mode |
Infrastructure mode (*1) |
Frequency |
2.4 GHz band 5 GHz band (*2) |
Channel |
2.4 GHz band: 1 to 13 ch 5 GHz band: 36 to 60 ch, 100 to 140 ch, 149 to 165 ch (increments of 4 ch) |
Encryption |
WEP (64bit/128bit) WPA (TKIP/AES) WPA2 (AES) WPA-PSK (TKIP/AES) WPA2-PSK (AES) |
Simple setup |
Supports WPS2.0 (button/PIN code) (*3) |
| *1: | You need a wireless access point which supports the same standards as this scanner. |
| *2: | Depending on the country or region where the scanner is purchased, it may not work with a 5GHz SSID. Change the wireless access point setting to use a 2.4 GHz SSID. |
| *3: | You need a wireless access point which supports the WPS function. |