Shortening the Scanning Intervals [Pre-Pick]

Enable this to shorten the scanning time when scanning continuously.

"Pre-pick" refers to feeding the next document into the ADF before ejecting the current document being scanned when scanning documents continuously.

  1. Start up the Software Operation Panel.

    For details, refer to Starting Up the Software Operation Panel.

  2. From the listing on the left, select [Device Setting 2] → [Pre-Pick].
    Pre-Pick
  3. Specify whether or not to enable pre-pick.

    Select [Yes] or [No].

    The factory default setting is [Yes].

    HINT

    • If you cancel in the middle of scanning while pre-pick is enabled, you have to remove the pre-picked document, then load the document again.

    • This setting can also be configured in the scanner driver.

      Note that priority is given to the scanner driver setting.