Correcting the Orientation of a Skewed Document to Feed the Document Straight [Automatic Skew Correction] (fi-8950/fi-8930)

Configure this setting to correct the orientation of a skewed document and feed the document straight.

  1. Start up the Software Operation Panel.

    For details, refer to Starting Up the Software Operation Panel.

  2. From the list, select [Device Setting 2] → [Automatic Skew Correction].
  3. To correct the orientation of a skewed document, select [Enable].

    The factory default setting is [Enable].

    When [Enable] is selected, specify the following items:

    Correction level

    Normal

    This is the factory default setting.

    High

    Document skewing can be corrected more than with [Normal].

    ATTENTION

    • For documents including thin paper, disable [Automatic Skew Correction] to prevent documents from being damaged.

    • If the rollers are dirty, automatic skew correction may be less efficient.

      If automatic skew correction becomes less efficient, clean the rollers.

      For details, refer to Daily Care.

    • When [Automatic Skew Correction] is enabled, scanning speed may be reduced.

    HINT

    • [Automatic Skew Correction] is disabled in the following cases:

      • When Manual Single Mode is used

      • When [Thin Paper Mode] is enabled

      • When [Pick Speed] is set to [Slower]

    • This setting can also be configured in the scanner driver or on the operator panel.

      Note that priority is given to the scanner driver setting.