Setting for Receiving Notifications about Dirt on the Glass [Notify when glass is dirty]

Configure this setting to send a notification about dirt on the glass.

Vertical streaks may appear on images if the glass is dirty.

When configuring this setting to send a notification about dirt on the glass, a message will be shown at the following times if there is a possibility of vertical streaks appearing on the image.

When the ADF is opened or closed
When scanning is finished
When documents are loaded onto the hopper
When the scanner wakes up from power saving mode

The touch screen displays a notification on when you receive a [Clean glass!] message.

When there is a message, is displayed.

Press to check the message, then clean the glass to prevent vertical streaks from appearing on images.

For details about cleaning, refer to Daily Care.

Start up the Software Operation Panel.

For details, refer to Starting Up the Software Operation Panel.
From the list, select [Device Setting 2] → [Notify when glass is dirty].
Select whether or not to receive notifications about dirt on the glass.
If you select [Notify], you will receive notifications about dirt on the glass.

The factory default setting is [Notify].
HINT
- This setting can also be configured in the operator panel.
- The function to receive notifications about dirt on the glass does not necessarily notify you of all the dirt. If vertical streaks appear on the image, take measures according to Vertical Streaks Appear on the Images.