Cleaning the (Carrier) Sheet
The (Carrier) Sheet should be cleaned with either a piece of dry cloth, a cloth moistened with Cleaner F1/mild detergent, or a sheet of Cleaning Wipe.
Gently wipe dirt and dust off the surface and the inside of the (Carrier) Sheet.
As you keep using the (Carrier) Sheet, dirt and dust will accumulate on the surface and the inside.
Clean it regularly because it may cause problems related to scanning or affect the scanned results.
Make sure that the (Carrier) Sheet is not creased.
To avoid deformation and discoloration, never use paint thinner or any other organic solvents.
Do not use force to rub against the (Carrier) Sheet because doing so may cause damage or deformation.
After cleaning the inside of the (Carrier) Sheet with a cloth moistened with Cleaner F1/mild detergent or a sheet of Cleaning Wipe, do not close the (Carrier) Sheet until it is completely dry.
The Carrier Sheet and Photo Carrier Sheet should be replaced approximately every 500 scans.
The Booklet Carrier Sheet should be replaced approximately every 2,500 scans.
Note that these guidelines vary depending on the type of documents scanned and how often the scanner is used and cleaned.
For information on purchasing the (Carrier) Sheets, contact the distributor/dealer where you purchased this product. Refer to the contact information in the Contact List if supplied with this product, or refer to the contact information in the Contact for Inquiries section if provided in Safety Precautions supplied with this product, and then make an inquiry.